Ryobi R18DDBL Traduction Des Instructions Originales page 4

Use of any other parts may create a hazard or cause
product damage.
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to various types of commercial
solvents and may be damaged by their use. Use clean
cloths to remove dirt and carbon dust.
Do not at any time let brake fluids, gasoline, petroleum-
based products, penetrating oils, etc., come in contact
with plastic parts. They contain chemicals that can
damage, weaken or destroy plastic.
Always wear safety goggles or safety glasses with side
shields during power tool operation or when blowing
dust. If operation is dusty, also wear a dust mask.
For greater safety and reliability, all repairs should be
performed by an authorised service centre.
LUBRICATION
All of the bearings in the product are lubricated with a
sufficient amount of high grade lubricant for the life span of
the product under normal operating conditions. Therefore,
no further lubrication is required.
ENVIRONMENTAL PROTECTION
Recycle raw materials instead of disposing
of as waste. The machine, accessories and
packaging should be sorted for environment-
friendly recycling.
E-TORQUE CONTROL
E-TORQUE CONTROL helps regulate the power output
of the product to avoid over-driving screws and damaging
materials. To achieve a flush finish, it is best to select a
low setting before commencing screw driving. When the
E-TORQUE CONTROL engages, the E-TORQUE selector
LED and E-TORQUE indicator LED will flash and the
product will automatically shut down.
If more power is required to drive the screw flush, the
E-TORQUE CONTROL can be adjusted accordingly.
E-TORQUE CONTROL only operates in screw driving
mode, it has no effect on drilling mode.
The product has a memory function that stores torque
settings. When switching from drilling to screwdriving
mode, the memory function restores previously used torque
settings. The E-TORQUE selector and indicator LEDs will
flash once previously used torque setting is reached.
SYMBOLS
Safety alert
CE conformity
2
English
No-load speed
EurAsian Conformity Mark
Please read the instructions carefully
before operating the product.
Ukrainian mark of conformity
Chuck capacity
Drilling without impact
Torque, maximum
Torque, minimum
Speed, minimum
Speed, maximum
Waste electrical products should not
be disposed of with household waste.
Please recycle where facilities exist.
Check with your local authority or
retailer for recycling advice.