Catalytic Cooking Compartment Panels; Removing And Fitting The Appliance Door; Removing And Inserting The Hook-In Racks - Bosch HSG736355M Notice D'utilisation

Catalytic cooking compartment panels

The catalytic cooking compartment panels are coated with self-
cleaning enamel.
The surfaces clean themselves while the oven is in operation.
Larger splashes will only be removed after the oven has been
used several times.
Self-cleaning surfaces
The side walls are covered with catalytic panelling. Never clean
these surfaces with oven cleaner. Slight discolouration of the
enamel does not affect automatic self-cleaning.

Removing and fitting the appliance door

You can remove the appliance door to clean it more
thoroughly.
Removing the appliance door
:
Risk of injury!
Whenever the hinges are not locked, they snap shut with great
force. When removing the oven door, ensure that the locking
pins are fully inserted into the holes in the hinges.
Open the oven door fully.
1.
Lock both hinges on the left and right using a locking pin (a).
2.
Note: The locking pins must be fully inserted into the holes in
the hinges.
Grip the oven door on either side with both hands and close
3.
the oven door by approx. 30° (b).
Raise the oven door slightly and pull it out.
4.
Note: Do not fully close the oven door. The hinges may
become bent and the enamel may be damaged.
Fitting the appliance door
Grip the oven door on either side with both hands.
1.
Slide the hinges into the slots in the oven (a).
2.
Note: The notch below the hinges must engage into the
frame of the oven (b).
Lower the door downwards.
3.
Remove the locking pins.
4.
:
Risk of injury!
If the oven door falls out accidentally or a hinge snaps shut, do
not reach into the hinge. Call after-sales service.

Removing and inserting the hook-in racks

You can remove the hook-in racks for easier cleaning.
Removing the hook-in racks
Unscrew the right and left-hand screws on the hook-in rack.
1.
Remove the hook-in rack.
2.
Inserting the hook-in rack
Hold the hook-in rack in front of the drill holes in the side
1.
panel.
Screw in the hook-in rack tight again using the screws.
2.
13