Kratki LUCY 12 Mode D'emploi Et Garantie page 14

General diagram of the insert
ash pan drawer
before lighting the fire for the first time, it is necessary to remove all labels or fittings from the ash
pan or the firebox. When the fire is lighted for the first time, a minimum temperature should be
maintained, with the door slightly open (approx. 1-2cm), so that the sealing material can merge with
the varnish. all materials must slowly adapt to high temperature. While used for the first few times,
the fireplace may give off an unpleasant smell caused by the combustion of paint. This smell will
dissipate within a short time. The room where the fireplace is located should be aired when the smell
is emitted.
Important: before lighting a large fire, it is necessary to light a small one two or three times. This
enables the structure of the fireplace to settle properly and the paint to cure. The firebox should not
be filled up with wood – an optimal amount of fuel occupies approximately 1/3 of the combustion
chamber's capacity. Wood can be added after the flames have dwindled, to such an extent that the
embers are not too intense.
Fuel: Given the construction the device, wood is recommended as fuel, including for example oak,
hornbeam, ash, beech, and the like. it is also permissible to use brown coal briquette. The best fuel is
seasoned wood (at least for a year in an airy and dry place) in cut and split chunks. igniting abruptly,
coniferous wood is not recommended. fresh or insufficiently dried wood is not a good fuel, for the
simple reason that it provides a limited energy efficiency. Using such wood may lead to an increased
emission of creosote, which settles in exhaust ducts. The devices of such a type must not be used to
burn minerals (e.g. coal), tropical wood (e.g. mahogany), chemical products or liquid chemicals, such
as oil, alcohol, petrol, naphthalene, laminated boards, impregnated or pressed pieces of glued wood,
or rubbish. if different fuel is permissible, information about this is given on the nameplate.
The enclosure of the fireplace insert should ensure air for circulating and ventilating purposes
by being equipped with vent grilles appropriate for the power of the insert (in the lower part
of the enclosure under the insert) and an outlet grille (in the upper part of the enclosure above
the insert).
We wish to thank you for the trust you put in us by buying a fireplace insert by kratki.pl. before
installing and using the fireplace insert, it is necessary to read the following instructions.
1. General remarks
a) before installing the fireplace insert, the chimney flue should be checked with regard to its techni-
cal parameters and technical condition.
14
combustion gas outlet
damper
door
window/glass
handle
primary air control