Husqvarna 535LK Manuel D'utilisation page 13

To fill the fuel tank
1. Clean the area around the fuel tank cap.
2. Shake the container and make sure that the fuel is
fully mixed. Use a fuel container with an anti-spill
valve.
3. Fill the fuel tank.
4. Tighten the fuel tank cap carefully.
5. Move the product 3 m (10 ft) or more away from the
refueling area and source before starting.
CAUTION: Contamination in the tanks
causes malfunction. Clean the fuel tank and
chain oil tank regularly and replace the fuel
filter one time a year or more.
Before you operate the product
• Examine the work area to make sure that you know
the type of terrain. Examine the slope of the ground
and if there are obstacles such as stones, branches
and ditches.
• Do an overhaul inspection of the product.
• Do the safety inspections, maintenance and
servicing that are given in this manual.
• Make sure that all covers, trimmer guard and
trimmer head correctly attached and not damaged or
cracked. Replace if they are exposed to impact or
cracked.
331 - 003 -
WARNING: Do not use the product without a
guard or a guard that is defective.
To prepare the product for start
1. Press the air purge again and again until the fuel
starts to fill the bulb.
Note: It is not necessary to fully fill the bulb.
2. Move the choke control up into choke position.
WARNING: The cutting attachment will
start to rotate immediately when you
start the engine with the choke.
To start the product
WARNING: Read the warning instructions in
the safety chapter before you start the
product (see
1. Use protective gloves.
2. Hold the body of the product on the ground with your
left hand.
CAUTION: Do not use your feet!
3. Hold the starter rope handle.
4. Slowly pull out the starter rope with your right hand
until you feel some resistance (the starter pawl grip).
Safety on page 4 ).
13