Fuse Check/Replacement/Reset; Safety Functions; Emergency Push-Button; Driver's Seat Microswitch - Nilfisk SR 1101 P Instructions D'utilisation

FUSE CHECK/REPLACEMENT/RESET

1. Drive the machine on a level ground and engage the
parking brake.
2. Turn the ignition key (82) to "0".
3. Open the hood (7).
4. Disconnect the battery negative connector (43).
Lamellar Fuse Check/Replacement
5. Remove the fuse box cover (46).
6. Check/replace the relevant fuse among the following (Fig.
18):
• (A): F1 main fuse (key circuit) (15 A)
• (B): F2 filter shaker motor fuse (25 A)
• (C): F3 manual vacuum system fuse (40 A) (optional)
• (D): F4 vacuum system motor fuse (30 A)
• (E): F5 horn and pivoting light fuse (10 A)
• (F): F6 working light fuse (10 A) (optional)
7. Remove the electrical component box cover (50).
8. Check/replace the following fuse (Fig. 19):
(A): FT drive system fuse (70 A)
9. Remove and check/replace the following fuse (63):
FR charging system fuse (70 A)
Fuse Check
10. Check one of the following fuses (Fig. 18) for deactivation:
(G): FA main broom motor fuse (30 A)
(H): FB side broom motor fuse (10 A)
Reset any deactivated fuse, when the component that
caused deactivation has fully cooled down.
11. Close the hood (7).

SAFETY FUNCTIONS

The machine is equipped with the following safety functions.

EMERGENCY PUSH-BUTTON

It is located in an easily accessible position (88). It has to be pressed in case of emergency, to stop all the machine functions.

DRIVER'S SEAT MICROSWITCH

It is inside the driver's seat and does not allow for engine start up when the operator is not on the driver's seat.
04/2009
INSTRUCTIONS FOR USE
A B C D
Figure 18
Figure 19
1464020000 - SR 1101 P
ENGLISH
G H
E F
P100348
A
P100349
23