Hopper Dumping; After Using The Machine; Pushing/Towing The Machine; Machine Long Inactivity - Nilfisk SR 1101 P Instructions D'utilisation

ENGLISH

HOPPER DUMPING

1. Stop the machine by releasing the drive pedal.
2. Turn the ignition key (82) to "0".
3. Engage the parking brake.
4. Disengage the hook (18) by pulling its lower end.
5. Remove the hopper (17) by using the handle (19) and by disengaging it from the inner guides.
Discharge all the debris into special containers. To make discharging procedure easier, inside the hopper there are two
different containers (optional) with handle (36).
6. Install the containers with handle (36), if equipped.
7. Install the hopper (17) and engage it to the inner guides, then fasten it with the hook (18).
8. The machine is ready to start sweeping again.

AFTER USING THE MACHINE

After working, before leaving the machine, perform the following procedures.
– Lift the side brooms with the lever (91).
– Lift the main broom with the lever (92).
– Turn on the filter shaker with the switch (85).
– Empty the hopper (17) (see the procedure in the previous paragraph).
– Remove the ignition key (82).
– Engage the parking brake.

PUSHING/TOWING THE MACHINE

To push/tow the machine when it is turned off, no special prearrangement is necessary.

MACHINE LONG INACTIVITY

If the machine is not going to be used for more than 30 days, proceed as follows:
– Perform the procedures shown in After Machine Use paragraph.
– Check that the machine storage area is dry and clean.
– Disconnect the battery connector (43).
– Handle the petrol engine as shown in the relevant Manual.

MAINTENANCE

The lifespan of the machine and its maximum operating safety are ensured by correct and regular maintenance.
The following chart provides the scheduled maintenance. The intervals shown may vary according to particular working conditions,
which are to be defined by the person in charge of the maintenance.
WARNING!
To perform maintenance procedures, the machine must be off, the ignition key removed, and, if necessary, the
batteries must be disconnected.
Moreover, carefully read the instructions in Safety paragraph.
All scheduled or extraordinary maintenance procedures must be performed by qualified personnel, or by an authorised Service
Center.
On the Instruction Manual, after the Scheduled Maintenance Table, shows only the simplest and most common maintenance
procedures.
NOTE
For other maintenance procedures shown in the Scheduled Maintenance Table, refer to the Service Manual that can be
consulted at any Service Center.
16
INSTRUCTIONS FOR USE
SR 1101 P - 1464020000
revised 03/2018
04/2009