GE JP328 Mode D'emploi page 13

INSTALLING THE COOKTOP
INSTALLING THE JUNCTION BOX
Install an approved junction box where it will be
easily reached through the front of the cabinet
where the cooktop will be located. The cooktop
conduit is 4 feet long.
Install junction box so
that it can be reached
through the front of the
cabinet.
IMPORTANT:
located where it will allow considerable slack in
the conduit for serviceability.
INSERT COOKTOP INTO CUTOUT
Insert the cooktop centered into the cutout
opening. Make sure the front edge of the
countertop is parallel to the cooktop. Make final
check that all required clearances are met.
49-80759
Installation Instructions
16"
Min.
The junction box must be
Cooktop
SECURE THE COOKTOP
Secure the tub of the cooktop to a standard counter
with the wood screws shipped with the cooktop.
Secure the tub of the cooktop to a tile counter
with 4 masonry screws. These can be purchased
at any hardware store.
ELECTRICAL CONNECTIONS
When making the wire connections, use the
A
entire length of conduit provided. The
conduit must not be shortened.
With the cooktop in place, open the front of
B
the cabinet door.
Insert the wires from the conduit through
C
the opening of the junction box. Secure
conduit with a matching strain relief clamp.
Red
Ground
D Connect the red and black leads from the
cooktop conduit to the corresponding leads
in the junction box.
Ground wire
location
Once the connections are made, secure
E
wires together using wire nuts.
Ground
IMPORTANT:
installed into a blind counter (one with no
cabinet opening below), wire connections must
be made before putting the cooktop into the
cutout opening.
Strain Relief Clamp
Black
Red
Black
Red
Strain Relief
Clamp
Black
If the cooktop is being
13