Makita DTM52 Manuel D'instructions page 4

ENGLISH (Original instructions)
SPECIFICATIONS
Model:
Oscillation per minute
Oscillation angle, left/right
Overall length
Net weight
Rated voltage
• Due to our continuing program of research and development, the specifications herein are subject to change
without notice.
• Specifications may differ from country to country.
• The weight may differ depending on the attachment(s), including the battery cartridge. The lightest and heavi-
est combination, according to EPTA-Procedure 01/2014, are shown in the table.
Applicable battery cartridge and charger
Battery cartridge
Charger
• Some of the battery cartridges and chargers listed above may not be available depending on your region of
residence.
WARNING:
Only use the battery cartridges and chargers listed above. Use of any other battery cartridges
and chargers may cause injury and/or fire.
Applicable application tool
Use the application tool which type is adaptable to this
tool as shown in the following table.
Intended use
The tool is intended for sawing and cutting wood,
plastic, gypsum, non-ferrous metals, and fastening
elements (e.g. nails and staples). It is also intended for
working soft wall tiles, as well as dry sanding and scrap-
ing of small surfaces. It is especially for working close to
edge and flush cutting.
with BL1820B
with BL1860B
OIS
STARLOCK
STARLOCK PLUS
STARLOCK MAX
10,000 - 20,000 min
BL1815N / BL1820B / BL1830B / BL1840B / BL1850B / BL1860B
DC18RC / DC18RD / DC18RE / DC18SD / DC18SE / DC18SF /
Noise
The typical A-weighted noise level determined accord-
ing to EN62841-2-4:
Work mode: Sanding
Sound pressure level (L
Uncertainty (K) : 3 dB(A)
The noise level under working may exceed 80 dB (A).
The typical A-weighted noise level determined accord-
ing to EN62841-1:
Work mode: Cutting with plunge cut saw blade
Sound pressure level (L
Uncertainty (K) : 3 dB(A)
The noise level under working may exceed 80 dB (A).
The typical A-weighted noise level determined accord-
ing to EN62841-1:
Work mode: Cutting with segmental saw blade
Sound pressure level (L
Uncertainty (K) : 3 dB(A)
The noise level under working may exceed 80 dB (A).
The typical A-weighted noise level determined accord-
ing to EN62841-1:
Work mode: Scraping
Sound pressure level (L
Uncertainty (K) : 3 dB(A)
The noise level under working may exceed 80 dB (A).
4 ENGLISH
DTM52
-1
1.8° (3.6° total)
305 mm
322 mm
1.7 - 2.0 kg
D.C. 18 V
DC18SH
) : 69 dB(A)
pA
) : 72 dB(A)
pA
) : 76 dB(A)
pA
) : 71 dB(A)
pA