Intended Purpose; Functional Parts; Assembly Instructions; Scope Of Delivery - Grizzly EGT 1345 Traduction De La Notice D'utilisation Originale

Intended purpose

The equipment is intended for use in the
DIY sector. It is not designed for constant
commercial use.
The tool is intended for breaking up and
tilling coarse soil for the purpose of mixing
in fertiliser, peat and compost in domestic
areas.
Any use other than that specifically
named in this manual may lead to dam-
age to the tool and represents a serious
injury hazard for the operator.
The operator or user of the tool is respon-
sible for any damage or injury caused to
other persons or property.
This tool is intended for use by adults.
Children and persons unfamiliar with the
manual must not be allowed to use the
tool. Do not use the tool in rain or damp
surroundings.
The manufacturer shall not be held liable
for damage arising from improper use or
incorrect operation of the tool.

Functional parts

1 Control element
2 Right hand handle bar
3 Release button
4 Starting lever
5 Left hand handle bar
6 Cable relief
7 2 central bars
8 Ventilation holes
9 Carrying bar
10 2 wheels
11 Cutting blade
12 Protective cover
13 Motor housing
14 Handle
15 Cable clamps
black hand wheel nuts
16 2
the handle bar
17 Mains cable

Assembly instructions

Scope of delivery

Carefully remove the tool from the pack-
aging and check that the following parts
are complete:
- Motor housing with cutting blade and
right hand handle bar
- Left hand handle bar
- Bar connector
- Central bar
- Cable clamp
- Cable relief
- Installation accessories
(6 black hand wheel nuts, 6 sheet
metal rings, 6 carriage bolts, 2 self-
tapping screws)
- User manual

Fitting the grip tubing

1. The cable relief (6) should be as-
2. Plug handle bars (2) and (5) into
3. Screw in place the central bar
4. Fix preassembled handle bars
to affix
Always disconnect the tool from the
mains before conducting any work on it.
While assembling the tool, make sure
that the mains cable does not be-
come caught and has enough slack.
sembled on right hand handle bar
(2) which is convenient for the user.
the bar connector (5a). Screw the
handle bars onto the bar connec-
tor from the rear with the 2 sheet
metal rings enclosed.
(7) with four carriage bolts, hand
wheel nuts and sheet metal
rings. Push in the carriage bolts
from outside.
(2) and (5) on the central bar (7)
in the same way with the car-
UK
87