Publicité
Les langues disponibles
Les langues disponibles
WP WALKY MAX
4-3)
BATTERY REPLACEMENT
-
Switch the handheld mic off
-
Open the battery cover
-
Pull of the old battery
-
Pull on the new one. Respect the polarity
-
Close the battery cover
5)
MAIN OPERATING
5-1)
WIRELESS SYSTEM OPERATING
WP WALKY MAX is equipped of two UHF wireless receivers ( One handhled transmitter + One belt transmitter ) .
-
Switch one or two receivers in using the corresponding volume controls ( buttons 10 and 11 of the control panel ). The yellow leds
light on..
-
Switch on one or two transmitters in using on/off switch. Of each transmitter.
-
If the led of receivers light on green, that means the UHF wire between transmitter and receiver is Good.
-
If one or two leds stay in yellow, that means the UHF wired between receivers and transmitters is defected. So you must to check the
batteries or transmitters . Check also if the receivers are on.
-
To save batteries life time, switch off the receivers if you don't need to use.
5-2)
CONNECTION OF WP WALKY MAX TO MAIN AC SOCKET
-
Connect the AC cord to main AC socket and to AC socket of WP WALKY MAX ( Note : 220V )
-
Switch the WP WALKY ON in using the power switch. The power led lights on.
-
If the main AC power supply is default, the WP WALKY MAX will operate on the built-in batteries.
NOTE : ac power plug must be pulled off after finishing charged or if you are not going to use it for a period of time
CAUTION : The power source switch of the WP WAKLY UHF must be on OFF position after use or the built in batteries would continue its
Power charge be needed every months to avoid damage of the built-in batteries or the Iife span of them will be shorten
5-3)
USE OF THE WP WALKY MAX ON BUILT-IN BATTERIES
-
Switch the WP WALKY MAX on in using the power switch. The power led lights on.
-
Switch off the speaker after use.
NOTE : If the LOW BATT led lights on, that mean the built-in batteries too low to do a normal operating. Connect the AC cord to
recharge the built-in batteries. If you continue to use speaker even when the batteries are low, you will reduce the life time of the
built in batteries ( perhaps you can destruct it ).
CAUTION : The power source switch of the WP WAKLY UHF must be on OFF position after use or the built in batteries would continue its
Power charge be needed every months to avoid damage of the built-in batteries or the Iife span of them will be shorten
HOW TO CHARGE THE BUILT-IN 7AH BATTERY ? :
-
It's recommended to charge for the first time use for 10 hours
-
Turn the main switch to OFF/CHARGE and the battery will be charged with a consistent current and voltage
-
The charging indicator will change to from bright to dim with the battery charging, the led will light off when the battery is full charged.
When the battery is getting low, you will hear a buzz reminder from the system, asking you to charge the battery immediately.
Recharge the battery over 8 hours before you are going to use it. When I is full charged over 8 hours, it can operate for more than 10
hours.
NOTE : Power charge be needed every months to avoid damage of the built-in batteries or the Iife span of them will be shorten
© Copyright LOTRONIC 2012
power release and result in damage of the built in batteries.
They are damaged in this case is on the user's own account due to its consumable.
power release and result in damage of the built in batteries.
They are damaged in this case is on the user's own account due to its consumable.
WWW.BSTDJ.COM
Page 18
Publicité
