BST WP WALKY MAX Manuel D'utilisation page 14

WP WALKY MAX
25. - CONNECTOR FOR DC POWER SUPPLY
Connect this socket to the – pin of the 12V power supply source.
26. POWER SWITCH
Select the "On" position to swith the speaker on. Select the "Off" position to switch the speaker off. Select "Off" position to recharge
Note : Before to connect the AC cord on this socket, make sure that the available voltage is not higher than stated at the end of this manual.
27. AC SOCKET
Before to connect the AC cord on this socket, make sure that the available voltage is not higher than stated at the end of this manual
The AC fuse is integrated on the power connector. It's used to avoid power supply default on speaker. If the ac cord is connected and power
switch push on the position ON but speaker doesn't work, please check the fuse. If the fuse is out of order, replace it by fuse with same size
and same value.
28. DRIVER
29. WOOFER
30. GRILL
31. FEET
32. UNLOCK BUTTON OF TROLLEY
33. INTEGRATED TROLLEY
34. CONTROL PANEL
35. SIDE HANDLE
36. WHEELS
3) USB / SD / CD PLAYER
3-1) USB / SD / CD PLAYER OPERATING
- To switch on the USB / SD / CD player, push the PWR button
- The bass and treble tone and volume are setup in factory ( volume = 11,Equaliseur=12 ).
- To switch off the USB / SD / CD player, push the PWR button another time
-
Note : To save life time of the batteries, switch the CD player off if you don't use it.
© Copyright LOTRONIC 2012
WWW.BSTDJ.COM
Page 14