Accessories - Gladiator Garageworks 2254086D Instructions D'assemblage

3. Completely tighten all back panel screws starting with the sides
and continuing with the top, middle, and bottom.
P5
Install Door Latch Bar
F3c Phillips-head screw (4 - black)
IMPORTANT: So the doors will close and lock, the latch bar (P8)
must be installed using the indicated pair of holes on each cabinet
side.
1. Align the latch bar with the pair of holes shown.
NOTE: Make sure the slot in the latch bar is facing down.
2. Using two Phillips-head screws (F3c) per side, fasten the latch
bar (P8) to the cabinet sides (P1 and P3).
P1
A
A. Holes for installing latch bar
B. Slot in latch bar
Install Shelf
F3c
F3c Phillips-head screw (4 - black)
IMPORTANT: The shelf may be installed using any of the lower sets
of holes in the cabinet sides.
1. Place the shelf (P9) in the cabinet so that the long edge with the
door magnets is facing out.
2. Align the holes in the shelf ends with the desired set of holes in
the cabinet sides (P1 and P3).
3. Using two Phillips-head screws (F3c) and two small flange nuts
(F5) per side, fasten the shelf to the cabinet sides (P1 and P3).
P2
D2
P1
P6
F3c
D5
P8
B
F5
F5 Small flange nut (4)
Install Doors
F3c Phillips-head screw (6 - black)
IMPORTANT:
The door with the lock assembly (P11) should be installed on the
right-hand side of the cabinet.
The door hinges are designed with keyhole slots at the top and
bottom so the door will hang on the cabinet while you are
fastening the screws.
1. Start Phillips-head screws (F3c) in both the top and bottom holes
on each side of the cabinet.
2. Hang the left-hand side door (P10) from the top and bottom
screws, and hand tighten.
3. Insert the middle two screws through the door hinge into the
cabinet and hand tighten.
P10
4. Repeat steps 2 and 3 to attach the right-hand door (P11).
5. Align the doors and completely tighten the screws.
Complete the Assembly
1. Make sure there is a bolt or screw in each hole of the cabinet
frame.
2. Move the cabinet to its final location.
3. Place a level on the inside shelf, and if necessary, level the
cabinet by adjusting the height of the leveling legs (P7). Turn to
the left to raise or to the right to lower the leveling leg.
4. If the doors are not aligned, loosen all the screws attaching the
door hinge to the cabinet.
5. Adjust door to the desired height, and fully tighten the screws.

ACCESSORIES

To order accessories, call 1-866-342-4089 and ask for the accessory
part number listed below or contact your authorized Gladiator
dealer. In Canada, call 1-800-807-6777.
Caster Kit
Order Part # GACK04KDSX
VersaTop™ Work Surface
Order Part # GAVT18SPSX
Modular Bamboo Top
Order Part # GAAC28BAYX
F3c
P2
D5
P8
P9
A
P4
® brand
5