Operating Manual; Introduction; How Does The Ergo + Whirpool System Work; Equipment - HOESCH ERGO+ Instructions De Montage Et D'utilisation

Masquer les pouces Voir aussi pour ERGO+:

Table des Matières

Les langues disponibles

Operating manual

Finally: you are about to bathe for the first time in your HOESCH whirl tub! We wish you a lot of pleasure in your new

bathtub! The fact that you have a highest quality product is the effect of constant monitoring of the product, research

and development works in connection with the innovative design of our luxurious bathtubs made of sanitary acrylic.

However, in order for your bathing not to be disturbed, we suggest reading this manual first.

The whirl system has a closed water circulation. The drain valve is at the same time the sucking connector. Water is

sucked in/ out, the whirl pump accelerates its flow so that the water under the pressure of approx. 1 bar is forced in by

massage jets to the inside of the bathtub. Thanks to the generated negative pressure an automatic air enrichment takes

place (this function can be switched on and off with the use of the remote control). Pipes between the jets and the pump

are located in such a way that they get empty during draining the bathtub. The air blower mixes the air in the ERGO +

system to give stronger and more powerful massage, reaching all parts of the body.

Hydromassage jet

Jet in the bottom

of the bathtub

Colorful lighting diodes

Remote control pilot

Heater

Table des Matières

Table des Matières