Operational Modes - socomec ATyS 3e Notice D'utilisation

Automatic Transfer Switch
OPERATION
ATyS 6s & 6e

Operational modes

VISUALISATION
Measured values & parametered timers display. Always
accessible without code.
PROGRAMMING
Parameters configuration. Password access (code 1000
from factory).
Programming
Code
Programming Visualisation
Programming
Code
Programming Visualisation
* only on ATyS 6e
PHASES ROTATION CONTROL
This feature allows in manual mode, to verify phases
rotation before commisionning.
V1
OK
V3 V2
or
1 2 1 2
source (source 1 or source
108
ATyS
POSITION
Operation
Code
Operation
Test off load
POSITION "AUT"
Control I, O, II*
Position Position Position
I O
V1
PROT
V2 V3
displayed according to faulty
2 ).
OPERATION
Test sequences or electrical control of the position.
Password access (code 4000).
Phases
rotation
control
Operation
Code
Operation
Test off load Test on load
II
Only source 1 phases rotation control on ATyS 6s & on
sources and
1 2
Function available on both sources (ATyS 6e) in
case of 4NBL or 3NBL type of network and only
on source 1
network (refer to annexes).
Presentation
Operational modes
Programming
Operation
Visualisation
Automatic sequences
Handle not
in place
Manual
Padlocking
emergency
operation
Loss of main
Main's return
source
sequence
sequence
on ATyS 6e.
in case of 41NBL or 42NBL
SOCOMEC - Réf.: 531 848 F