CareFusion MicroRPM Manuel D'utilisation page 48

Guidance and Manufacturer's Declaration – Electromagnetic
Emissions
The MicroRPM is intended for use in the electromagnetic environment
specified below. The customer or the user of the MicroRPM should assure
that it is used in such an environment
Emission Test
RF emissions
CISPR11
RF emissions
CISPR11
Harmonic
Emissions
IEC 61000-3-2
Voltage
fluctuations /
flicker emissions
IEC 61000-3-3
Guidance and Manufacturer's Declaration – Electromagnetic
Immunity
The MicroRPM is intended for use in the electromagnetic environment
specified below. The customer or the user of the MicroRPM should assure
that it is used in such an environment.
Immunity
Test
Electrostatic
discharge
(ESD)
IEC 61000-4-2
Electrical fast
transient/burst
IEC 61000-4-4
Compliance
Group 1
Class B
[Not Applicable]
[Not applicable]
IEC 60601 test
level
+/- 6 kV contact
+/- 8 kV air
+/- 2 kV for
power supply
lines
+/- 1 kV for
input/output
lines
Electromagnetic
Guidance
The MicroRPM uses RF energy only for
its internal function. Therefore, its RF
emissions are very low and are not
likely to cause any interference in
nearby electronic equipment.
The MicroRPM is suitable for use in all
establishments, including residential
establishments and those directly
connected to the public low-voltage
power supply network that supplies
buildings used for domestic purposes.
Compliance
Level
+/- 6 kV contact
+/- 8 kV air
+/- 1 kV for
input/output
lines
45
Environment
Electromagnetic
Environment
Guidance
Floors should be
wood, concrete or
ceramic tile. If
floors are covered
with synthetic
material, the
relative humidity
should be at least
30%.
Mains power quality
should be that of a
typical commercial
or hospital
environment.
-
-