Installation; Inserting/Replacing The Battery; Mounting - EuroLite FL-100 Mode D'emploi

Masquer les pouces Voir aussi pour FL-100:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

This device must only be operated in an altitude between -20 and 2000 m over NN.
Never use the device during thunderstorms. Over voltage could destroy the device. Always disconnect the
device during thunderstorms.
Operate the device only after having familiarized with its functions. Do not permit operation by persons not
qualified for operating the device. Most damages are the result of unprofessional operation!
If the device will not be used for a longer period of time, remove the battery in order to avoid battery leakage.
Never use solvents or aggressive detergents in order to clean the device! Rather use a soft and damp cloth.
Please use the original packaging if the device is to be transported.
Please consider that unauthorized modifications on the device are forbidden due to safety reasons!
If this device will be operated in any way different to the one described in this manual, the product may suffer
damages and the guarantee becomes void. Furthermore, any other operation may lead to dangers like short-
circuit, burns, electric shock, etc.

INSTALLATION

Inserting/Replacing the battery

Please refer to the explanations under Operating Determinations.
Open the battery cover on the bottom and remove it.
If replacing the battery, remove the old battery from the battery compartment.
Caution!
Danger of explosion when battery is replaced improperly.
Only replace by the same type or similar types recommended by the manufacturer.
Remove empty battery in accordance with the instructions of the manufacturer.
Insert the battery and make sure that the poles are correct.
Replace the battery cover and close it.
In order to have a long battery life, you should only use alcaline batteries.
BATTERY DISPOSAL NOTICE
Please dispose of old and used batteries properly.
Batteries are hazardous waste and should not be disposed of with regular domestic waste!
Please take old and used batteries to a collection center near you.

Mounting

When standing the device on a plane surface, please extract the 3 legs.
If the device is used as torch, please extract the 3 legs and insert them in the fixation holes of the shaft.
Hanging installation:
The installation of the device has to be built and constructed in a way that it can hold 5 times the weight for 1
hour without any harming deformation.
11/20
00053023.DOC, Version 2.2

Publicité

Table des Matières
loading

Table des Matières