Troubleshooting - Sony RM-TP501E Mode D'emploi

Troubleshooting

If you experience any of the following difficulties while
using the commander, use this troubleshooting guide to
help you remedy the problem. Should any problem
persist, consult your nearest Sony dealer.
Operation cannot be done with the commander.
/ Check that the amplifier and components are
connected correctly.
/ The commander and amplifier are too far apart.
/ Make sure that there are no objects between the
commander and amplifier.
/ Make sure that the amplifier's power is turned on.
/ The commander's transmitter/receiver section is
not pointed at the amplifier.
/ The commander's batteries are exhausted. Replace
with new alkaline batteries (see page 7).
/ There is an invertor system florescent light near the
commander or amplifier. Please place away from
the florescent light.
/ Make sure you have selected the correct function
on the remote.
/ When you operate a programmed non-Sony
component, the remote may not function properly
depending on the make and model of the
component.
The amplifier's functions and modes do not
correlate with the displays on the commander.
/ Initial communication setup has not been done.
Use after first carrying out initial communication
setup (see page 6).
/ The commander was not pointed at the amplifier
when it was turned on. Touch RELOAD, and
download component data (see page 8).
/ Select the correct function using the commander.
LCD does not appear.
/ The LCD is not turned on. Touch the touch panel.
/ Contrast is too light or too dark.
Use the CONTRAST control to adjust the contrast
of the LCD (see page 6).
When a CD player, tape deck, or MD deck is
connected to the amplifier via S-LINK CONTROL
A1 jacks, Auto Function does not work properly.
/ Reprogram the remote (see page 19).
24 GB