Operating Problems - Zanussi ZWY 1100 Notice D'utilisation

1
2
4
7
Water inlet filters
To clean, proceed as follows :

Operating Problems

Numerous checks were carried out on your
appliance before it left the factory. However,
should you notice a malfunction, please refer
Problems
The appliance doesn't
start or doesn't fill:
www.zanussi.com
6
5
3
8
9
10
CLACK
11
CLACK
• the appliance isn't plugged in correctly, the electrical installation isn't work-
ing, there is a power failure,
• the lid of your appliance and the drum shutters aren't closed firmly,
• the programme start command hasn't been properly selected,
• the water supply has been cut off, the water inlet tap is closed,
• the water inlet filters are dirty (see "Care and cleaning ").
Precautions to be taken against frost
If your appliance is exposed to temperatures
below 0°C, the following precautions must be
taken:
• Close the tap and disconnect the inlet hose.
• Place the end of this hose and the drain
hose in a basin on the floor.
• Select the Drain programme let it run until
the end of the cycle.
• Disconnect the appliance from the power
supply by turning the programme selector to
"Stop" .
• Unplug the appliance.
• Replace the inlet hose and drain hose.
This way, the water remaining in the hoses will
be drained away, avoiding any ice formation
which would damage your appliance.
Before turning your appliance on again, ensure
that it is installed in an area where the temper-
ature will not fall below freezing.
NOTE ! This machine is made for use in nor-
mal inside temperature. Manufacturer is not re-
sponsible for freezing damages.
to the sections below before contacting the
after-sales service.
Causes
9