Operating Problems - Zanussi ZWY 1100 Notice D'utilisation

7

Operating Problems

Numerous checks were carried out on your ap-
pliance before it left the factory. However,
should you notice a malfunction, please refer to
Problems
The appliance doesn't start
or doesn't fill:
The appliance fills but
empties straight away:
The appliance doesn't
rinse or doesn't empty:
The appliance doesn't
spin:
You have found water
around the appliance:
8
8
9
10
CLACK
11
CLACK
• the appliance isn't plugged in correctly, the electrical installation isn't work-
ing, there is a power failure,
• the lid of your appliance and the drum shutters aren't closed firmly,
• the programme start command hasn't been properly selected,
• the water supply has been cut off, the water inlet tap is closed,
• the water inlet filters are dirty (see "Care and cleaning ").
• the drainage U-piece is fixed too low (see "Installation").
• the drain hose is blocked or bent,
• the drainage filter is obstructed (see "Care and cleaning "),
• the out of balance detector has been activated: washing is unevenly distrib-
uted in the drum,
• the "Drain" programme or "Night Cycle" or "Rinse hold" option have been
selected,
• the height of the drainage U-piece is unsuitable.
• balance problem with the laundry load: add more laundry or manually adjust
the items in the drum.
• too much detergent has caused foam to overflow,
• the detergent is unsuitable for machine washing,
• the drainage U-piece isn't attached correctly,
• the water inlet hose is leaking.
Water inlet filters
To clean, proceed as follows :
the sections below before contacting the after-
sales service.
Causes
www.zanussi.com