Installation - Zanussi ZWY 1100 Notice D'utilisation

Installation

Remove all protective packaging for transit be-
fore using for the first time. Keep in case nee-
ded for future transit: Transporting a non-se-
cured appliance may damage internal compo-
nents and cause leakages and malfunctions.
The appliance can also be damaged through
physical contact.
Unpacking
1
2
Untying
A B
C
D
B
2
1
www.zanussi.com
Keep the transit bolts
for when you move
the appliance.
1
2
Water supply
In case of necessity
move the inlet hose in
the direction shown
A
on picture. To make
this loose the inlet
hose ring nut and po-
sition the inlet hose
downwards as drawn
on picture. Tighten
the ring nut back and
make sure there are
1 B
no leaks.
2
To install the appli-
ance at the same lev-
el as neighboring fur-
niture, cut these plas-
tic pieces.
90 90 90
O O O
Open the water inlet
tap. Check there are
no leaks. The water
inlet hose can not be
extended. If it is too
short, please contact
the after-sales serv-
ice.
Note ! Check if the
water connections
are tight.
D
11