Publicité
Les langues disponibles
Les langues disponibles
Installation Instructions – LD4B/LD6B Commercial Recessed LED Rough-In
Cleaning
To Clean Trims:
1.
Press in on white plastic latch to remove upper
reflector and clean lens. (Figure 12 & 13.)
2.
Gently wipe with soft, clean, dry lint-free cloth to
remove dust.
3.
Wipe with mild detergent solution on a soft, clean
cloth to remove fingerprints and stains.
4.
Rinse with clean water and dry with soft, clean, dry lint-
free cloth.
White
Plastic Latch
Figure 12
Figure 13
Figure 14
4
Upper Reflector
Lens
Installation Instructions – LD4B/LD6B Commercial Recessed LED Rough-In www.eaton.com
Electrical Connection
CAUTION
Make certain no bare wires are exposed outside of wire nut
connectors.
1.
Provide electrical service according to the "National
Electrical Code" or your local electrical code to the
junction box (located on the plasterframe). Supply wire
insulation must be rated for at least 90°C. The junction
box is rated for a maximum of 8 No. 12 AWG Branch
Circuit conductors and is also suitable for at least 90°C
2.
Remove junction box cover (Figure 14.).
3.
Remove appropriate round pryout and connect conduit
to junction box with proper connector (not included).
4.
Connect supply lead wires to junction box lead wires
(line, neutral and ground) in the fixture using the
provided lever nut connectors. (Figure 16). Be careful
not to leave any bare conductors outside of the lever
nut connectors.
5.
Lift the orange tab on the lever nut to disengage the
wire and close to secure the wire in place. (Figure 16).
6.
Connect white to white, black to black, and green
(from electrical service) on the supply side to the bare
copper wire in the junction box. Place all excess wiring
and connections into the junction box and replace the
cover. Place all connections and excess wiring into the
junction box and replace cover.
Driver Replacement
CAUTION
To avoid possible electrical shock, be sure that the power is
turned off before installing or servicing this fixture.
• The driver should be replaced by a qualified electrician.
• The driver may be replaced either from below or above the
ceiling.
1.
Remove trim assembly from the housing (Figure 9.).
2.
Remove the driver and junction box cover assembly.
(Figure 15.).
3.
Disconnect the wiring to the driver by undoing the lever
nut connectors then cut the red and blue wires.
4.
Discard the old driver and junction box cover assembly.
5.
Connect the new driver leads with the lever nut
connectors.
6.
Reattach the new driver and junction box cover
assembly.
Publicité
