Access To Usb Port - Whirlpool W11449282C Instructions D'installation

Technician Service Access Code
This method is only available on NON-COIN washers set to free
vend (6 00).
To enter service mode:
Press the HEAVY DUTY, EXTRA RINSE, TEMPERATURE, and
DELICATES keypads within 10 seconds.
To exit service mode:
From service code 8.xx, press the HEAVY DUTY keypad
for 4 seconds.
or
Wait 2 minutes without touching any keypads (without diagnostic
modes running).
or
Power down the washer, then re-apply power.
NOTE: If a service cycle is in progress upon exiting service mode,
the cycle will complete normally with cycle status information
displayed. The display will resume normal customer operation
mode when the cycle ends.

ACCESS TO USB PORT

Access to USB Port on Appliance if Using USB
Stick to Change Electronic Controls Settings
WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before operating.
Failure to do so can result in death or electrical shock.
To Install or Remove a USB Stick
USB Port is located on the Display Control Board.
1. Remove the two screws to allow the Fascia Panel to be rotated
outward from appliance.
2. Lay fascia panel face down on appliance top panel to provide
access to User Interface Control Board.
3. Install the USB Stick into USB Port or remove USB Stick from
USB Port.
4. Replace fascia panel onto appliance with the two screws
previously removed.
WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
5. Plug appliance into a grounded 3 prong outlet or reconnect
power.
15