Disposing Of The Unit; Names And Functions Of Various Parts; How To Operate; On/Off - Mitsubishi Electric CITY MULTI PEFY-P-VML-A Manuel D'utilisation

Warning:
• Do not remove the front panel or the fan guard from the outdoor unit
when it is running. You could be injured if you touch rotating, hot or high-
voltage parts.
• Never insert fingers, sticks etc. into the intakes or outlets, otherwise in-
jury may result, since the fan inside the unit rotates at high speed. Exer-
cise particular care when children are present.
• If you detect odd smells, stop using the unit, turn off the power switch
and consult your dealer. Otherwise, a breakdown, electric shock or fire
may result.
• When you notice exceptionally abnormal noise or vibration, stop opera-
tion, turn off the power switch, and contact your dealer.
• Do not over-cool. The most suitable inside temperature is one that is
°
within 5 C of the outside temperature.
• Do not leave handicapped people or infants sitting or standing in the path
of the airflow from the air-conditioner. This could cause health problems.
Caution:
• Do not direct the airflow at plants or caged pets.
• Ventilate the room frequently. If the unit is operated continuously in a
closed room for a long period of time, the air will become stale.
In case of failure
Warning:
• Never remodel the air conditioner. Consult your dealer for any repair serv-
ice. Improper repair work can result in water leakage, electric shock, fire, etc.
• If the remote controller displays an error indication, the air conditioner
does not run, or there is any abnormality, stop operation and contact

2. Names and functions of various parts

Attachment and detachment of filter
[Fig. A] (P.6)

3. How to operate

C
CENTRALLY CONTROLLED
E
CHECK
˚C
STAND BY
DEFROST
TEMP.
1
3
2
PAR-20MAA TIMER SET
4
Before starting operation
• Start running after the "H0" display has disappeared. The "H0" display briefly
appears on the room temperature display (max. 3 minutes) when the power is
turned on and after a power failure. This does not indicate any failure of the air
conditioner.
• The operation modes of the indoor units' cooling operation, dry operation, and
heating operation are different from those of the outdoor units.
When the operation is started with cooling/dry (heating) and other indoor units
connected to the counterpart outdoor units are already running in the same
operation mode, the remote control displays "
the operation comes to stop, and you cannot get a desired mode. When this
occurs, you will be notified by the "
liquid crystal display of the remote controller. Set to the operation mode of
other indoor unit by the operation switch button.
The above does not apply to the models that simultaneously run both the cool-
ing operation and heating operation.
• The outdoor units stop when all the indoor units connected to the counterpart
outdoor units stop.
• During heating operation, even if the indoor unit is set to operation while the
outdoor unit is in defrosting operation, operation starts after the defrosting op-
eration of the outdoor unit has ended.
8
A
1Hr.
ON OFF ˚C
CLOCK
FILTER
CHECK MODE
TEST RUN
ERROR CODE
FUNCTION
NOT AVAILABLE

ON/OFF

B
FILTER
CHECK TEST
6 8 7
" or " " (" ") mode. However,
" or " " (" ") display that flashes in the
your dealer. Leaving the unit as it is under such conditions can result in
fire or failure.
• If the power breaker is frequently activated, get in touch with your dealer.
Leaving it as it is can result in fire or failure.
• If the refrigeration gas blows out or leaks, stop the operation of the air
conditioner, thoroughly ventilate the room, and contact your dealer. Leav-
ing the unit as it is can result in accidents due to oxygen deficiency.
When the air conditioner is not to be used for a long
time
• If the air conditioner is not to be used for a long time due to a seasonal
change, etc., run it for 4 - 5 hours with the air blowing until the inside is
completely dry. Failing to do so can result in the growth of unhygienic,
unhealthy mold in scattered areas throughout the room.
• When it is not to be used for an extended time, keep the [power supply]
turned OFF.
If the power supply is kept on, several watts or several tens of watts will
be wasted. Also, the accumulation of dust, etc., can result in fire.
• Keep the power switched ON for more than 12 hours before starting op-
eration. Do not turn the power supply OFF during seasons of heavy use.
Doing so can result in failure.

1.3. Disposing of the unit

Warning:
When you need to dispose of the unit, consult your dealer. If pipes are re-
moved incorrectly, refrigerant (fluorocarbon gas) may blow out and come
into contact with your skin, causing injury. Releasing refrigerant into the
atmosphere also damages the environment.
Caution:
• In removing the filter, precautions must be taken to protect your eyes
from dust. Also, if you have to climb up on a stool to do the job, be careful
not to fall.
• Turn off the power supply when the filter is changed.
3.1. ON/OFF
Start an operation
1. Press the B B B B B [ON/OFF] button
Operation lamp V lights up and operation starts.
Stop an operation
1. Press the B B B B B [ON/OFF] button again
Operation lamp goes off and operation stops.
• Once the buttons have been set, pressing of the [ON/OFF] button only can
repeat the same operation thereafter.
• During operation, the operation lamp above the [ON/OFF] button lights up.
Caution:
Even if the operation button is pressed immediately after the operation is
once stopped, operation is not restarted for about 3 minutes. This function
protects the machine. It automatically starts operation after the lapse of ap-
proximately 3 minutes.

3.2. Selecting operation

When selecting operation
1. Press the 3 3 3 3 3 [selecting operation] button
Consecutive press of the selecting operation button switches the operation
over to E "
," " ," " ," (" "), and ("
check the display.
For cooling
Press the 3 3 3 3 3 [selecting operation] button and bring up the "
For dry
Press the 3 3 3 3 3 [selecting operation] button and bring up the " " display.
• The indoor fan turns to the low-speed operation, disabling the change of fan
speed.
Dry operation cannot be carried out at a room temperature of less than 18 °C.
•
For fan
Press the 3 3 3 3 3 [selecting operation] button and bring up the "
• The fan operation functions to circulate the air in the room.
• The temperature of the room cannot be set by fan operation.
"). For the contents of operation,
" display.
" display.