Carbon Monoxide Detection (Must Be Enabled By Your Installer); Fire Detection (Must Be Enabled By Your Installer); Testing; Monitoring - Johnson Controls tyco HS2TCHPRO Manuel De L'utilisateur

Introduction

Carbon Monoxide Detection (must be enabled by your Installer)

This equipment is capable of monitoring carbon monoxide detectors and providing a warning if carbon monoxide
is detected. Please read the Family Escape Planning guidelines in this manual and instructions that are available
with the carbon monoxide detector.

Fire Detection (must be enabled by your Installer)

This equipment is capable of monitoring fire detection devices such as smoke detectors and providing a warning
if a fire condition is detected. Good fire detection depends on having adequate number of detectors placed in
appropriate locations. This equipment should be installed in accordance with NFPA 72 (N.F.P.A., Batterymarch
Park, Quincey MA 02269). Carefully review the Family Escape Planning guidelines in this manual.

Testing

To ensure that your system continues to function as intended, you must test it weekly. Please refer to the "Testing
your System" section in this manual. If your system does not function properly, call your installing company for
service.

Monitoring

This system is capable of transmitting alarms, troubles and emergency information to a central station. If you ini-
tiate an alarm by mistake, immediately call the central station to prevent an unnecessary response.
Note: The monitoring function must be enabled by the installer before it becomes functional.
Note: There is a communicator delay of 30 seconds in this control panel. It can be removed, or it can be increased
up to 45 seconds, at the option of the end-user by consulting with the installer.
Note: For CP-01 systems, the monitoring function must be enabled by the installer before it becomes functional.

Maintenance

With normal use, the system requires minimum maintenance. Note the following points:
Use the system test described in "Testing Your System" to check the battery condition. We recommend,
l
however that the standby batteries be replaced every 3 - 5 years.
For other system devices such as smoke detectors, passive infrared, ultrasonic or microwave motion
l
detectors, or glassbreak detectors, consult the manufacturer's literature for testing and maintenance
instructions.

Important Notice

A security system cannot prevent emergencies. It is only intended to alert you and, if included, your central sta-
tion of an emergency situation. Security systems are very reliable but they may not work under all conditions, and
they are not a substitute for prudent security practices or life and property insurance. Your security system should
be installed and serviced by qualified security professionals who should instruct you on the level of protection
that has been provided and on system operations.
- 7 -