Troubles; Alarm Memory - Johnson Controls tyco HS2TCHPRO Manuel De L'utilisateur

Troubles

When a trouble condition is detected, the Trouble (
beep every 10 seconds. Press the (
!
Trouble ( ) or System indicator will flash. The corresponding trouble will light up.
Troubles
Service
Required (Press
for more
details)
If the building and/or neighborhood has lost electrical power, the system will
AC Loss
continue to operate on battery for several hours.
Phone Trouble The system has detected that the telephone line is disconnected.
Communication The system attempted to communicate with the monitoring station, but failed.
Failure This may be due to Telephone Line Fault.
The system is experiencing difficulties with one or more sensors on the system.
Zone Fault
Press to display the zone.
The system has detected a tamper condition with one or more sensors on the sys-
Zone Tamper
tem. Press to display the zone.
The system has detected a low battery condition with one or more mod-
Wireless Low
ules/sensors on the system. Press to display the zone, keypad, wireless key(s) and
Battery
RF Delinquency low battery conditions. Press again to see zone troubles.
If complete power was lost (AC and Battery), the time and date will need to be
Loss of Clock
reprogrammed.
[01] Interactive zone: The number of zones configured in the panel is not sup-
ported by ADC firmware (e.g.:>220)
Limit Exceeded
[02] Interactive partition: The number of partitions configured is not supported
by ADC firmware (e.g.:>8)

Alarm Memory

When an alarm occurs, the Alarm indicator flashes.
To view which sensor(s) generated the alarm, press Alarms.
The sensor number where the alarm occurred will be displayed (e.g., zone 3). Use the [<][>] scroll keys to view the
sensors in alarm memory. Press Back or Home to exit. To clear the memory, arm and disarm the system. If an alarm
sounded while armed, the keypad will automatically go to alarm memory when you disarm the system. In this
instance, you should approach with caution, as the intruder may still be within the building/premises.
!
) key to silence the beeps. Press (
Low Battery
Bell Circuit
General System Trouble
General System Tamper
!
) or System indicator will turn on, and the keypad will
!
Comments
General System Supervision
RF Jam Detected
Panel Low Battery
Panel AC Loss
- 14 -
) to view the trouble condition. The
Troubles
Action
Call for
service
Call for
service
Call for
service
Call for
service
Call for
service
Call for
service
Call for
service
Reprogram
Time &
Date