Chime Enabled/Disabled; Arming; Partition Status - Johnson Controls tyco HS2TCHPRO Manuel De L'utilisateur

Figure 10- Clean Mode
Home Page:
can be configured in one of two different views, Classic (square buttons) and Contemporary
(rondel).

Chime Enabled/Disabled

Door Chime:
To turn the door chime function On/Off, tap the Chime icon. 3 beeps indicate that the chime is
ON. 1 long beep indicates the Chime is OFF.

Arming

Stay Arm:
arms the system in Stay mode
Away Arm:
arms the system in Away mode
Night Arm:
To fully arm the system when it has been armed in Stay Mode, press Night Arm button. All interior
zones will now be armed except for devices programmed as Night Zones. Night zones are only armed in Away
mode. This permits limited movement within the premises when the system is fully armed. Ensure that your
installer has provided you with a list identifying zones programmed as night 18 zones. When the interior zones
have been activated (i.e., Night Arm), you must enter your access code to disarm the system to gain access to
interior areas that have not been programmed as night zones.
Quick Exit:
refer to the section: Quick Exit
Global Away Arm:
arms all partitions to which the User Code is assigned, in Away mode.
Global Stay Arm:
arms all partitions to which the User Code is assigned, in Stay mode.
No Entry Arm:
arms the system with no entry.

Partition Status

To view the partition status, press Options, User Functions, then Partition Status. The keypad shows basic status
for up to 8 partitions, depending on the configuration of your system. Each partition is identified along with its
current status.
- 22 -
Options Menu