Disarm; Away Arm; Exit Delay Time Restart; Alarm Cancel Window - Johnson Controls tyco HS2TCHPRO Manuel De L'utilisateur

Arming and Disarming the System
The Disarm screen is displayed.
l
The Ready Indicator turns OFF.
l
"Stay Armed-Bypass" is displayed in the Status Bar.
l
Note: This screen will go into stand-by mode after 15 minutes. Tap the screen to restore the display.

Disarm

If Disarm is selected:
A numerical keypad is displayed.
l
Enter your Access Code in the keypad.
l
The system returns to the Home screen and the red Armed indicator turns OFF.
l
The alarm status is momentarily displayed in the status bar, then "Ready" is displayed.
l
The green Ready indicator turns ON.
l
Note: If your code is invalid, the system will not disarm and a 2-second error tone will sound. If this happens,
press # and try again.

Away Arm

When Away Arm is selected:
Enter a valid access code to proceed.
l
The Armed LED Indicator turns ON.
l
"Exit Delay in Progress" is displayed in the Status Bar. The pre-programmed exit delay begins.
l
The touchscreen "beeps" at a 1-second urgency interval during the exit delay. Then 3 beeps sound in the
l
last 10 seconds.
Note: If Quick Arm is not enabled by the installer, a numerical keypad is displayed.
If Disarm is selected during the exit delay:
A numeric keypad is displayed. Tap your access code.
l
The Arming sequence is aborted and the system returns to the Home screen.
l
The Armed LED turns OFF.
l
At the end of the pre-programmed exit delay:
The Disarm screen is displayed.
l
The Ready Indicator turns OFF.
l
"Away Armed" is displayed in the Status Bar.
l

Exit Delay Time Restart

The control panel provides an option where if an entry/exit zone is tripped, a second time prior to the end of the
exit delay, the exit delay time restarts. The exit delay timer can only be restarted once.

Alarm Cancel Window

The control panel provides a period of time in which the user can cancel the alarm transmission. The minimum dur-
ation of this time is five minutes. If the programmed alarm transmission delay has expired, canceling an alarm
sends a message to the monitoring station. Upon a successful transmission of the cancelation message, the keypad
will beep 6 times.
- 11 -