Handling The Cutter Head - B.Braun Aesculap Econom CL Mode D'emploi

Aesculap®
Econom CL/Econom CL Equipe cattle and horse clipping machine
Remove the lithium ion battery 39, and push the charged and/or
uncharged replacement lithium ion battery GT801 into the battery-
operated clipping machine gsee Fig. 2.
Fig. 2
Secure the lithium ion battery 39 using the battery lock fsee Fig. 3.
Fig. 3
6
39
39
f

4.5 Handling the cutter head

Lubricating the cutter head
Damage to the clipping machine or the cutter
head due to incorrect lubrication!
Only oil the cutter head when the machine is
CAUTION
running.
Never immerse the cutter head in liquid of any
kind!
Only use GT604 light lubricating oil.
Generously oil the cutter head at the lubrication point a before
shearing each animal, see Fig. A.
Oil spring leaves 10 2 to 3 times daily with 3 to 4 drops of oil, see
Fig. C.
Lubricating the gear wheel
Damage to the clipping machine or the gear wheel
due to incorrect lubrication!
Use only gear grease GT605.
CAUTION
Lubricate the gear wheel 1 to 2 times during
the shearing season.
Unlocking and removing the lithium ion battery 39.
Remove both screws 6, see Fig. B.
Then turn the cutter head very slightly (about 15°) counterclockwise
and remove it from the motor shell.
Apply approximately 1 cm of grease on the two opposite points of the
gear wheel 11, see Fig. C.
Carefully place the cutter head on the motor. When re-attaching the
cutter head, ensure that it is turned 15° counterclockwise in such a
way that its lower flange engages with the groove of the motor
housing.
Changing the cutter plate
Unlocking and removing the lithium ion battery 39.
Loosen the locking cap 3
approximately 2 turns, see Fig. A.
Loosen both clamp screws 9, pull off the cutter plate 1 forwards and
remove the upper cutter plate 2, see Fig. D and Fig. E.
Before inserting the upper cutter plate 2, ensure that the oscillating
block 8 is in the intended recess of the oscillator 7, see Fig. E.
Insert the upper cutter plate 2. When doing so, ensure that both tips b
of the oscillator 7 engage precisely in the holes c of the upper cutter
plate 2, see Fig. D.
and adjusting screw 4 by