Operation - Bartscher 150320 Mode D'emploi

Connection
DANGER! Electric shock hazard!
The device can cause injuries due to improper installation!
Before installation and connecting the local power grid specification should
be compared with that of the device (see rating plate). Connect the device
only in case of compliance!
Connect the device only to properly installed single socket with
protective terminal.
•
The electrical circuit in the socket must be secured to at least 16A. Only connect the
device directly to the wall socket; do not use any extension cords or power strips.

5.2 Operation

•
Before the first use, clean the device according to the instructions included
in section 6 „Cleaning".
•
Turn the ON/OFF knob to „OFF" position.
•
Connect the electric hot-plate to a single-phase socket.
•
Place the food in a suitable cookware on the hot plate.
NOTE!
Do not use unstable dishes that may easily tip over.
Use dishes with a flat bottom only, in order to ensure total contact
with the hot plate, to ensure maximum use of the generated heat.
•
Turn the ON/OFF knob to the „ON" position.
- 26 -
•
Set the desired temperate for a selected hot plate.
•
By turning the temperature regulator right you can
regulate the temperature in an infinitely variable way
within the range from „MIN" to „MAX".
•
The orange control light comes on and goes off when
the desired temperature is reached. When the tempe-
rature drops, the thermostat is activated and the hot
plate starts heating again. The orange control light
comes on again.