Unpacking - Ryobi RY48130 Guide D'assemblage

 Remove the bolts securing the corner and side braces
to the frame bottom, then lift the braces to remove.
 Cut the nylon straps securing the front and rear wheel
axles to the frame.
 Remove boxes containing loose parts, assembly hardware,
and documentation.
 Remove and set aside all accessible packaging and wrap
from unit and parts. Do not discard the packing material
until you have carefully inspected and satisfactorily oper-
ated the product.
WARNING:
If any parts on the Loose Parts List are already as-
sembled to your product when you unpack it, verify the
part is assembled correctly, is properly tightened, and is
torqued correctly (where applicable) before proceeding
to the next assembly step. Use of a product that may
have been improperly assembled could result in serious
personal injury.
 Inspect the product carefully to make sure no breakage
or damage occurred during shipping.

UNPACKING

 If any parts are damaged or missing, please call
1-800-860-4050 for assistance.
NOTE: Mower should be assembled while positioned on the
frame bottom. Once assembly is complete, raise the cutting
deck to its highest position, then position a ramp next to the
frame bottom and slowly and carefully drive mower off frame.
WARNING:
Use care when driving the mower off of the frame and
press the brake pedal as needed to control the speed.
The mower will freely roll if it is moved on an inclined
surface without pressing the brake pedal or setting the
parking brake. Failure to follow these instructions can
result in loss of control and result in death, serious per-
sonal injury, or property damage.
NOTICE:
If no ramp is available, slowly and carefully drive the
mower off the frame in reverse while looking down and
behind. Driving the mower off the frame in the forward
direction without a ramp can cause damage to the
mower's cutting deck.
4 — English