Hilti TE 6-A36 Mode D'emploi page 13

2. From the front, slide the depth gauge into the 2 guide holes.
3. Tighten the side handle clamping band by turning the handle grip.
5.5 Fitting and adjusting the depth gauge
▶ Fit the depth gauge, if necessary, and adjust it correctly.
5.6 Fitting / removing the chuck
CAUTION
Risk of injury! The depth gauge, if fitted but not used, might hinder the operator.
▶ Remove the depth gauge from the tool.
▶ Fit / remove the chuck.
5.7 Inserting accessory tool
1. Lightly grease the connection end of the accessory tool.
▶ Use only genuine Hilti grease. Using the wrong grease can result in damage to the tool.
2. Push the accessory tool into the chuck as far as it will go (until it engages).
3. After fitting the accessory tool, grip it and pull it in order to check that it is securely engaged.
▶ The product is ready for use.
5.8 Removing the accessory tool
▶ Pull the chuck back as far as it will go and remove the accessory tool.
5.9 Overhead work
▶ Fit the DCD dust control ring for overhead work.
*2100248*
5
6
7
2100248 English 7