La Pavoni Bar Mode D'emploi page 32

17
BAR SVR MODEL
17
HOTEL VR MODEL
17
3
BAR D MODEL
This model is equipped with automatic, continuous delivery
brewing units with solenoid valve and programmable coffee
dosing, microprocessor-aided sealed digital brewing control, con-
trol board with 4 different coffee-dose selection positions, a stop
button for each brewing unit, programmable coffee counting com-
puter on each unit and for each cup, a timer-aided hot water deli-
very system, programmable water consumption and digital clock.
13
13
15
13
31
COFFEE DOSE PROGRAMMING DIRECTIONS FOR THE
BAR V - HOTEL V - BAR D - BARSV MODELS
17 A B
17 A B
17. UNIT CONTROL:
Key function:
A. 1 normal cup of coffee.
B. 2 normal cups of coffee.
C. 1 "large" cup of coffee.
D. 2 "large" cups of coffee.
E. Brewing unit stop/continuous delivery.
The "*" (E) button is designed for continuous delivery and delivery stop.
The machine therefore has a double function:
By pressing the "*" (E) button, the equipment is run as a semi-
automatic machine.
By pressing the 4 selection buttons, the machine is operated throu-
gh electronic dosing.
By holding the "*" (E) button pressed for over 10 seconds, the
machine will enter the programming phase, as signalled by the
low frequency flashing of the LED belonging to the unit on which
programming is being carried out.
Release the programming button (the LED will continue to flash) and
press the button relating to the unit on which you wish to program-
me coffee dosing; at this stage delivery will start; once the desired
dose has been reached, press any button of the unit concerned to
interrupt delivery; the dose will be stored in the memory and the
machine will exit the programming phase (the LED will stop flashing
and switch off).
1. This operation should be repeated on the remaining selection
buttons for the various groups.
2. The same operation needs to be repeated if you wish to incre-
ase or decrease the set dose.
3. By programming the first unit to the left, the programming ope-
ration will be also accomplished on the various groups.
N.B. The programming phase is signalled by the flashing LED of
the unit on which programming is being carried out.
HOT WATER DOSE PROGRAMMING DIRECTIONS FOR
THE BAR V MODEL AND BAR D MODEL
By holding the "*" (E) button pressed for over 10 seconds, the
machine will enter the programming phase; release the program-
ming button (the LED will continue to flash) and press the hot-water
delivery switch (15); hot water delivery from the telescopic nozzle
(13) will start; once the desired dose has been reached, press the
hot water delivery switch to stop water supply. The LED will switch
off, the dose will be stored in the memory and the machine will exit
the programming stage.
C D E
C D E
English