Philips AVENT SCD831 Mode D'emploi page 8

8
English
Preparing for use
Baby unit
Parent unit
- Make sure that your hands are dry when you handle adapters, plugs and
the mains cord.
- All required markings on the baby unit, parent unit and power adapter
are located on the bottom of the baby unit, parent unit and power
adapter.
Compliance with standards
- This product complies with the radio interference requirements of the
European Community.
- Philips Consumer Lifestyle hereby declares that this baby monitor is in
compliance with the essential requirements and other relevant provisions
of Directive 2014/53/EU (FHSS: frequency band 2.4GHz, maximum radio-
frequency power: 100 mW EIRP). A copy of the EC Declaration of
Conformity (DoC) is available online at www.philips.com/support.
Electromagnetic fields (EMF)
This Philips appliance complies with all applicable standards and
regulations regarding exposure to electromagnetic fields.
Put the power adapter in the baby unit and the adapter in the wall socket.
The parent unit runs on a built-in rechargeable Li-ion battery.
Follow the below steps to charge the parent unit:
1 Put the power adapter in the parent unit and put the adapter in the wall
socket.
-
The battery status light turns orange to indicate that the appliance is
charging.