Philips AVENT SCD831 Mode D'emploi page 20

20
English
1
20°C
1
20°C
Belt clip
Cleaning and maintenance
If your baby only makes soft sounds, the sensitivity of the baby unit needs
to be set to a high sensitivity level on the parent unit.
The louder your baby sounds, the lower the sensitivity can be set on the
parent unit.
Note: In AUDIO and VIDEO mode, you will have continuous sound when the
sensitivity level is on 'very high'. Otherwise, low sounds will be muted.
Tip: The sensitivity level can be adjusted so you will always hear your baby
without the disruption of other sounds. When there is a lot of background
noise, turn the sensitivity lower so you will not hear these sounds through
the parent unit.
You can take the parent unit with you inside and outside the house by
attaching the parent unit to your belt or waistband with the belt clip. This
allows you to monitor your baby while you are moving around.
Note: The display is now turned upside down, which allows you to see your
baby on the screen by simply lifting up the parent unit.
Warning: Do not immerse the parent unit, baby
unit and power adapters in water and do not
clean them under the tap.