Using The Single-Serve Cup - Ninja BN642 Guide D'utilisation

USING THE TOTAL CRUSHING® PITCHER - CONT�
IMPORTANT: Review all warnings on
pages 4–7 before proceeding.
IMPORTANT: As a safety feature, if the
pitcher and lid are not properly installed,
the timer will display "---" and the motor
will be disabled. If this happens, repeat
step 5 on page 13. When the pitcher and
lid are properly installed, the program
button LEDs will illuminate, indicating
the appliance is ready to use.
9 To pour out thinner mixtures, ensure the
lid is locked in place, then open the pour
spout cap.
14 ninjakitchen.com
10 For thicker mixtures that cannot be
emptied through the pour spout, remove
the lid and Stacked Blade Assembly
before pouring. To remove the lid, press
the RELEASE button and lift the handle.
To remove the blade assembly, carefully
grasp it by the top of the shaft. The
pitcher can then be emptied.
11 Unplug the unit when finished. To
release the motor base, place your hands
underneath both sides of the motor
base and gently pull the unit up and
toward you. Refer to page 17 for storing
instructions.

USING THE SINGLE-SERVE CUP

IMPORTANT: Review all warnings on
pages 4–7 before proceeding.
NOTE: Pre-set programs have pauses
and changes in speed throughout the
cycle.
TIP: To learn more about the unit's
programs, refer to previous page.
1 Place the unplugged motor base on a
clean, dry, and level surface such as a
countertop or table. Press downward on
the motor base to adhere the suction cups
to the work surface. Plug the motor base
into a wall outlet.
2 Add ingredients to the Single-Serve Cup.
DO NOT add ingredients past the MAX
LIQUID line on the cup.
3 Install the Pro Extractor Blades Assembly
®
onto the top of the cup. Twist the lid
clockwise until it's sealed tightly.
4 Turn the Single-Serve Cup upside down
and install onto the motor base. Align the
tabs on the cup with the slots on the base,
then rotate cup clockwise until it clicks
into place. When the unit is connected
to power and the container is correctly
locked onto the motor base, press
the Power symbol to turn unit on. The
available program buttons will illuminate
and the unit will be ready for use.
ninjakitchen.com
15