Télécharger Imprimer la page

GGP ITALY TI 48 Li Manuel D'utilisation page 32

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 29
EN
SAFETY REGULATIONS
TO BE OBSERVED SCRUPULOUSLY
IMPORTANT – READ CAREFULLY BEFORE USING
THE MACHINE. KEEP FOR FUTURE REFERENCE
INTENDED USE - This equipment is intended for soil cultivation only.
Use the equipment for this purpose only. Using for any other purposes
may cause serious injury and/or damage to the equipment.
A) TRAINING/ INFORMATION
1.
Do not insert battery into the equipment until it is ready to be
used.
2.
Be familiar with the controls and proper use of the equipment.
3.
Never allow children or people unfamiliar with the instructions
to use the machine. Local regulations can restrict the age of
the operator.
4.
Never work while people, especially children, or pets are
nearby.
Do not operate the equipment while under the influence of
5.
drugs, alcohol, or any medication.
6.
Keep in mind that the operator or user is responsible for
accidents or hazards occurring to other people or their property.
B) PREPARATION
1.
While working, always wear substantial footwear and long
trousers. Do not operate the equipment when barefoot or
wearing open sandals.
Thoroughly inspect the area where the equipment is to be used
2.
and remove all objects which can be thrown up by the machine.
3.
Before using, always visually inspect to see that the tools
are not worn out or damaged. Replace worn out or damaged
elements and bolts in sets to preserve balance.
C) OPERATION
Work only in daylight or in good artificial light.
1.
2.
When working on slopes:
– Make sure that there are no children or other people within a
working range of 20 meters (66 ft), also pay attention to any
animals in the working vicinity. Otherwise stop using the tool.
– always be sure of your footing,
– work across the slopes, never up and down,
– exercise extreme caution when changing direction on slopes.
3.
Do not work on excessively steep slopes.
4.
Walk, never run with the machine.
5.
Use extreme caution when reversing or pulling the machine
towards you.
6.
Start the motor carefully according to manufacturer instructions
and with feet well away from the tool(s).
7.
Do not put your hands or feet near or under rotating parts.
8.
Never pick up or carry a machine while the motor is running.
9.
Switch off the equipment and remove the battery in the cases
below:
– whenever you leave the machine unattended,
– before clearing blockages.
Pay particular attention on hard or stony field because the
10.
machine tends to be much less stable than on cultivated ground
and use slow speed for ploughing.
D) MAINTENANCE AND STORAGE
Before storing the machine in a confined or closed place, let it
1.
cool down for a sufficient period of time.
2.
Keep all nuts, bolts and screws tight to ensure the equipment is
in safe working condition.
To reduce the fire hazard, keep the motor, battery compartment
3.
and storage area free of vegetative material and excessive
grease.
4.
Switch off the equipment and remove the battery in the cases
below:
– before checking, cleaning or working on the machine,
– after striking a foreign object. Inspect the machine for damage
and make repairs before restarting and operating the machine,
– if the machine starts to vibrate abnormally. Inspect for
damage and replace or repair any damaged parts. Check for
32
and tighten any loose parts.
E) BATTERY TOOL USE AND CARE
Recharge only with the charger specified by the manufacturer.
1.
A charger that is suitable for one type of battery pack may
create a risk of fire when used with another battery pack.
Use power tools only with specifically designated battery packs.
2.
Use of any other battery packs may create a risk of injury and
fire.
3.
When battery pack is not in use, keep it away from other metal
objects, like paper clips, coins, keys, nails, screws or other small
metal objects, that can make a connection from one terminal
to another. Shorting the battery terminals together may cause
burns or a fire.
Under abusive conditions, liquid may be ejected from the
4.
battery; avoid contact. If contact accidentally occurs, flush with
water. If liquid contacts eyes, additionally seek medical help.
Liquid ejected from the battery may cause irritation or burns.
F) SERVICE
Have your power tool serviced by a qualified repair person using
1.
only identical replacement parts. This will ensure that the safety
of the power tool is maintained.
2.
Follow instruction for lubricating and changing accessories.
3.
Keep handles dry, clean and free from oil and grease.
SAVE THESE INSTRUCTIONS.
WARNING - DO NOT let comfort or familiarity with product (gained
from repeated use) replace strict adherence to safety rules for the
subject product. MISUSE or failure to follow the safety rules stated
in this instruction manual may cause serious personal injury.

Publicité

loading