Kenwood NX-220 Mode D'emploi page 31

■ Reviewing Messages in the Stack Memory
1 Press the key programmed as [Stack], or press and hold
the key programmed as [Selcall], [Status], or [Selcall +
Status] to enter Stack mode.
• The last received message is displayed.
2 Press the <B or C> key to select the desired message.
• Message types are identifi ed as follows:
ID: Caller ID, ST: Status Message, ME: Short Message
• Press and hold the S key for 1 second to cycle the display
information as follows:
ID Name > Status/Short Message > CH/GID
3 Press the Side 1 key to return to normal operation.
• To delete the selected message, press the A key. To
confi rm the deletion, press the S key.
• To delete all messages, press and hold the A or # key for
1 second. To confi rm the deletion, press the S or
SHORT MESSAGES
This transceiver can receive short data messages which
contain a maximum of 48 characters.
• Received short messages are displayed the same as Status
messages. A maximum of 15 received messages (combined
status messages and short messages) can be stored in the stack
memory of your transceiver.
GPS REPORT
To send your location data, you must fi rst connect a GPS unit
to the transceiver. GPS data can be manually transmitted by
pressing the key programmed as [Send the GPS data]. If set up
by your dealer, GPS data may be automatically transmitted at a
preset time interval.
key.
19