How To Attach The Camera Table To The Digital Camera; Using The Ufl-2 Underwater Electronic Flash With The Underwater Optical Fiber Cable - Olympus PT-E05 Mode D'emploi

How to attach the camera table to the digital camera

In order to load the camera into the Case, attach the camera table (located on the front-lid side of the
Case) to the digital camera.
1 The eyecup and the hot shoe cover of the digital
camera can be stored in the camera table.
2 Attach the camera table to the tripod seat section on
the bottom of the digital camera. Use the camera's
tripod screw hole for attaching.
3 The camera table has fixed up-down and front-rear
orientations. To ensure that it is properly attached,
refer to the illustration on the right.
Using the UFL-2 underwater electronic flash with the underwater
optical fiber cable
1 Set the RC mode of the camera to ON so that the camera's built-in flash is activated.
En
2 Load the camera in the Case with the camera's built-in flash popped up.
Refer to the UFL-2 instruction manual for the UFL-2 operation.
EN 19
Front
Up
Down
Rear