Olympus PT-E05 Mode D'emploi page 63

3 When using a slave flash from a non-Olympus manufacturer, push the # button on the camera to
pop up its built-in flash.
CAUTION:
The built-in flash should be popped up before loading the camera in the Case. Once the case has been
sealed, the built-in flash cannot be popped up from outside the Case. To pop up the flash after the case has
been sealed, change the camera's automatic pop-up setting to ON, set the camera to a scene mode other
than AUTO and underwater modes, point the camera at the subject and half-press the shutter button so that
the built-in flash pops up automatically.
4 After attaching the camera table to the digital camera, slide the camera table into the Case's camera
table-loading groove. Do not insert the camera table by force. Slide it in gently while checking that
the digital camera does not interfere with the internal parts of the Case.
# button
En
EN 22