Front Panel; Rear Panel - Alesis ELEVATE 4 Guide D'utilisation

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

Features

Front Panel

1.
Tweeter: This outputs the high frequencies.
2.
Woofer: This outputs the low frequencies.
3.
Headphones: Connect your 1/8" (3.5 mm) headphones
to this output to hear the mix through your headphones.
1
Note that while headphones are connected to Elevate 4,
you will not be able to hear sound out of your speakers
3
until the headphones are disconnected.
4.
Volume / Power On/Off Switch: This knob is used to
turn the speakers on and adjust their volume. To turn on,
simply turn up the knob. You will feel a click when the
speakers turn on. A LED on the left side of the speaker
will illuminate. To turn off, simply turn the volume all the
way down; the LED will turn off to let you know that the
speakers are off. To save energy, Elevate 4 will
automatically power off after 30 minutes of not receiving
an audio signal from its inputs. Once Elevate 4 detects
an audio signal from its inputs, it will automatically
power on again.

Rear Panel

1.
RCA Inputs: Use RCA cables (sold separately) to
connect an external sound source to these inputs.
2.
1/4" Inputs: Use 1/4" (6.35 mm) cables (sold separately)
to connect an external sound source to these inputs.
3.
Bass Boost: This switch allows you to boost the
speakers' bass frequencies.
4.
Bass Port: The bass port augments the bass generated
by the woofer to increase the low-frequency SPL over
that of non-ported speakers. Make sure this hole is not
obstructed
since
response.
5.
Right Speaker Output: This is the audio connection to
the left speaker. Use the included 1/8" (3.5 mm)
interconnection cable to connect the right speaker to the
left speaker.
6.
Left Speaker Input: This is the audio connection to the
right speaker. Use the included 1/8" (3.5 mm)
interconnection cable to connect the left speaker to the
right speaker.
7.
1/8" Stereo/Subwoofer Output: This is a full range
audio output which can be connected to a mixer,
powered speakers, or an external recording device.
8.
Power Connector: Plug the included power cable here.
4
2
7
5
8
this
will
adversely
4
6
1
3
5
affect
bass
1
2
3
4
2
7
8
1
2
4
4
6
3

Publicité

Table des Matières
loading

Table des Matières