User Settings; Access; Backlight Setting; Setting The Frost Protection Temperature - RADSON Hydronic PTC BLOWER 950W Notice D'utilisation

EN

USER SETTINGS

ACCESS

You access to User settings in 3 steps:
From Auto, Comfort, Eco or Frost protection mode :
Information display
1
1
Press for 5
seconds
Setting sequence:
Backlighting Frost protection temperature

BACKLIGHT SETTING

1- Three modes can be set:
Version without occupancy detector:
L1
= Temporary backlighting: Backlight of the display when a but-
ton is pressed.
L2
= Non-stop backlighting: Backlight of the display all the time.
L3
= In this version, the device will work according to the L1 mode.
Version with occupancy detector:
L1
= Temporary backlighting: Backlight of the display when a but-
ton is pressed or during occupancy detection.
L2
= Non-stop backlighting: Backlight of the display all the time.
L3
= Temporary backlighting: Backlight of the display when a but-
ton is pressed.
L3 mode is the default setting.
Press or to choose the setting you require.
2- Press to save and move to the next setting.
To exit the user settings, press
M16MI325 A03_06/18
2
Press briefly
twice
Maximal Boost duration
twice.
Information display
1
Maximum ambient temperature
SETTING THE FROST PROTECTION
TEMPERATURE
Your device is preset at 7°C. You can adjust the Frost protection
temperature from 5°C to 11°C, by intevals of 0.5°C.
3- Press or to obtain the temperature you require.
4- Press to save and move to the next setting.
To exit the user settings, press
SETTING OF THE MAXIMUM DURATION
OF AUTHORISED BOOST
The maximum duration of Boost is preset at 60 minutes. You can adjust
it from 30 to 90 minutes by intervals of 30 minutes.
7- The Boost symbol and the heating indicator appear on the display
and the preset duration of 60 minutes flash.
8- Press or to display the desired duration.
User
= user settings
twice.
3
Press briefly
12