Removing The Roller Shutter Belt Winder (E. G. In The Event Of A Move) - WR RolloTron Standard Série Mode D'emploi Et D'installation

i

15. Removing the roller shutter belt winder (e. g. in the event of a move)

1.
Erase all settings.
Press and hold the [ Reset ] key
for 2 seconds.
2.
Fully close the roller shutters.
3.
Keep the [ Down ] key held down.
4.
In doing so, pull out the belt as far as possible from
the top of the roller shutter belt winder.
5.
Remove the cover plates from the mounting holes.
6.
Remove the mains plug or switch off the mains power.
7.
Subsequently release the fastening screws and pull
the roller shutter belt winder completely out of the
belt box.
8.
Remove the belt compartment cover.
96
Standard device
EN
Device for large belt boxes