Electrical Connection - WR RolloTron Standard Série Mode D'emploi Et D'installation

i

8.1 Electrical connection

1.
Connect the desired cable.
The colour coding is irrelevant for the installation.
A damaged connecting cable may cause a short
circuit.
◆ Ensure that the connecting cable is laid safely.
◆ The connecting cable muse not be pinched or dam-
aged when screwing on the belt winder.
2.
Lay the connecting cable safely.
◆ If you use a cable with an mains plug, then this should
be subsequently laid in the roller shutter belt winder
cable duct.
3.
Finally, screw on the traction relief mechanism with the
screws provided.
Standard device
Traction
relief
Cable duct
Device for large belt boxes
e. g. mains power plug cable:
2 x 0.75 mm H03WH2-F
2 -
Traction relief
EN
87