WR RolloTron Standard Série Mode D'emploi Et D'installation page 91

i
11. End point adjustment
Set the lower end point
4.
Press and hold the Set key.
5.
Press the [ Down ] key once
The roller shutter moves downwards.
6.
Release the Set key, ...
...as soon as the roller shutter achieves the
desired position for the lower end point.
The roller shutter stops and the lower end
point is stored.
Changing or correcting the end points
7.
Move the roller shutters to the centre position and
configure the respective end point again.
NOTE
After a period of time it may be necessary to re-configure
the end points as the belt may elongate during the process
of operation.
IMPORTANT
Please ensure that the belt is not excessively slack when
reaching the lower end point.
EN
91