Erase All Settings, Reset - WR RolloTron Standard Série Mode D'emploi Et D'installation

14. Erase all settings, reset

If necessary, you can erase all of your settings and return
the roller shutter belt winder system to its original factory
settings.
1.
Press and hold the [ Reset ] key for
2 seconds.
2.
Release the [ Reset ] key, ...
◆ ... subsequently all of the settings will be deleted,
(end points / switching times).
3.
The control LED flashes by way of
confirmation.
4.
Carry out the settings again as detailed from page
90 onwards.
EN
95