Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
English
Press the FM mode / alarm button to set the
"hour". The "minutes" indicator blinks. Turn the
select dial or press the search button to select the
desired "minutes".
4. Press the FM mode / alarm button to save the set
time.
The ALARM indicator goes off .
5. The display changes in order of [buzzer
alarm→radio alarm→no display] each time the FM
mode / alarm button is pressed.
6. The power turns on and the buzzer sounds or the
radio plays when the preset time is reached.
Buzzer Alarm
To turn off the buzzer alarm, press the FM mode
/ alarm button. If it is not turned off , the buzzer will
continue to sound for 1 minute and then stop.
Radio Alarm
To turn off the radio, press the power button. If it is
not turned off , the radio will continue to play for 30
minutes.
To check the alarm
To check the time set on the alarm, press the band
selector button with the power turned off .
LISTENING TO THE PORTABLE
MUSIC PLAYER
Connecting an External Device
You can use the radio to listen to a portable music
player as MP3 player, smartphone, etc.
CAUTION
● Reduce the volume before switching on the
power.
Sudden loud volume output may result in
damage to the speakers or cause hearing
loss.
● Do not store external devices in the storage
case in environments subject to direct
sunlight or high temperatures. Failure to
observe this may result in damage to the
equipment.
● Check the inside of the storage case for
sand and other foreign matter before storing
external devices in it, and clean out any
foreign matter that exists. Failure to observe
this may result in the equipment becoming
scratched or otherwise damaged.
16
NOTE
Certain models of smartphones will not emit call
tones from their speakers when connected to the
radio. Check whether your smartphone emits call
tones via the speakers prior to use.
1. With the radio and the external device both turned
off , connect the audio cord (3.5 mm dia. available
at an electric store) of the external device to the
AUX input terminal on the inside of the external
device storage case on the radio. (Fig. 8)
Audio cord
AUX IN
NOTE
There are two types of connection cable available:
straight cables and L-shaped cables. Use
L-shaped cables when connecting and storing
large-scale external devices. (Fig. 9)
2. Turn on the radio and press the band select button
to display [AUX].
NOTE
The display changes in the order of
[FM→AM→AUX→FM] each time the band select
button is pressed.
3. Turn on the external device to start listening.
4. Adjust the volume.
NOTE
Volume may not increase if the peripheral
equipment's volume output level is low.
Belt
Fig. 8
Fig. 9
Publicité
Table des Matières
