HAIRCUT TH31 Guide De L'utilisateur page 24

4 Use
4.1 Switching on
Once the clipper battery has been charged, switch the clippers on by pressing the
button (Figure 1, E). The "On" icon (Figure 1, J) is animated.
4.2 Use with or without power lead
With a new, fully charged battery, the clippers can be used without the power lead
for about 90 minutes, as is shown by the value displayed (Figure 1, K). Five minutes
before the end of the autonomy period, the charge symbol (Figure 1, L) flashes to
show that it is necessary to charge the clippers or use the direct mains power
supply mode. The clippers can then be used with the power lead connected directly
to the clipper socket (Figure 2).
4.3 Adjusting the cutting height
Figure 4: Adjusting the
cutting height.
Possible cutting heights: 1.0 mm, 1.3 mm, 1.6
mm and 1.9 mm.
To reduce the cutting height (cut the hair
shorter): push the sliding knob (B) upwards.
Set the cutting height as shown by the
indicator (C).
To increase the cutting height (cut the hair
longer): press the release button (A) and push
the sliding knob (B) downwards. Set the
cutting height as shown by the indicator (C).
Constant care must be taken when using the
clippers near the ears. Protect the ear with
your hand to avoid all risk of injury due to the
cutter.
24