Publicité
Les langues disponibles
Les langues disponibles
user's instructions
function - Assembling
•
Make sure the device is placed on a stable, flat surface.
•
The air vents at the side and bottom of the device should not be blocked.
•
During assembling the device should not be plugged into a socket.
1. Place the grinding cilinder in the head with the longer side towards the head (see figure 1). Turn the
grinding cilinder slightly until it is secured inside the 'head' (part number 2).
2. Place the spinning blades onto the shaft of the grinding cilinder with the cutting edge towards the front
(see figure 2). If the spinning blades are placed incorrectly the device will not grind any meat.
3. Place the desired grinding disc (part number 8) by setting the protruding parts into the slots (see figure
3).
4. Keep the grinding disc in its place by pressing it in the middle with a single finger. Use your other hand
to turn the locking ring (part number 3) secure (see figure 4). Do not turn the locking ring any further
than is required.
5. Hold the head with a single hand and position it into the crevice in the device (see figure 5), use your
other hand to stick the locking knob (part number 10) into the hole on the side of the housing (see
figure 6). Turn it clockwise to secure the head.
6. Place the feeding tray on top of the head.
function - Grinding meat
•
Only use the presser (part number 4) supplied with the device to push food into the device
•
Cut all the food into pieces that'll easily fit into the opening. Sinewless, boneless and fatless meat
is recommended.
1. Put the plug into the socket. Push the "R/ON" switch (part number 11) into the "ON" position. Put the
"ON/OFF/Reverse" switch (part number 12) in the "ON" position (this is the position where the switch
remains pressed). The device is now turned on.
2. Use the presser to push food from the feeding tray (part number 1) into the opening (see figure 8).
3. Shut the device down after use and pull he plug from the socket.
function - "reverse" function
When the device jams, set the the "R/ON" switch into the "R" position. Put the "ON/OFF/Reverse switch in
the "Reverse" position (this is the position where you need to keep pressing down the switch). The grinding
cilinder will run in the opposite direction, allowing you to dislodge the blocking element,
If you can not manage to remove the blocking element by utilizing the "Reverse" function you need to
shut down the device, disassemble the head and clean it.
All manuals and user guides at all-guides.com
23
Publicité
