Dismantling; Technical Details; Faults - Vetus GWDS Manuel D'utilisation Et Instructions D'installation

7

Dismantling

• Switch off the power.
• Drain the drainpipe thoroughly.
• Disconnect all supply and drain pipes.
If the lid of the GWDS has been opened moisten the rubber seal with
liquid soap or detergent before resealing it.
9

Faults

Make sure that the power is disconnected when carrying out any necessary repairs.
Fault
The motor starts spontaneously
The motor runs continuously or for a long
time
The motor will not start
The motor makes a noise but does not run
(does not pump)
The motor starts but stops spontaneously
GWDS
8

Technical details

Voltage
Current
Connections
Capacity of container
Maximum vertical lift
Maximum horizontal
displacement
Pump capacity at
discharge height
of 4 metres
Maximum liquid
temperature
Noise level
Protection
Weight
Possible cause
Taps are dripping
The non-return valve is faulty
The vertical lift is too high / There is too
much water flushing through / There are too
many bends in the installation
The equipment is not connected or the
power supply is faulty
The fuse has blown
The motor is faulty
The motor is damaged or the condenser is
faulty
The thermal protection system has been
activated because the waste water is too
hot.
ENGLISH
: 12 V 24 V 120 V
: 28 A 14.5 A 6.5 A
: 1x ø 40 mm
1x ø 32 / 40 mm
1x ø 12 mm
1x ø 19 mm (drain)
: 3.5 litres
: 4 m
: 40 m
: 44 litres/min
: 35˚C for a short period
: 40 dBA
: IP44
: 3.5 kg
Solution
Check and repair the taps (replace the gas-
kets)
Clean or replace the non-return valve
Check and change the installation
Connect the equipment or repair the power
supply
Mend the fault and replace the fuse
Consult a qualified engineer
Consult a qualified engineer
Allow the motor to cool off for an hour. The
thermal protection system will automatical-
ly switch on.
230 V
1.2 A
9
110120.01