Loading Media In Peel-Off Mode - Sartorius YDP30 Mode D'emploi

3.2.2 Loading Media in Peel-off Mode

1. Refer to Section 3.2.1 to load the media.
2. Open the top cover and peel-off panel after calibrating the sensor.
Peel-off
panel
3. Release the paper from the support material. Guide the support material through
the "Backing paper opening."
Peel-off
roller
Backing
paper open-
ing
4. Push the peel-off panel back to the printer.
5. Close the top cover gently.
6. Press the FEED button to do a test.
Backing
paper (liner)
Setup
Operating Instructions YDP30 9